Get a 3/4th inch offset box end wrench, 16 point and grind the tip at about a 30 deg angle for about half the width of the box end:
- rs_DSCN0383.jpg (105.76 KiB) Viewed 2332 times
This taper allows for the box end to fit between the lower king pin bearing housing/bolts and the inner brake adjuster:
- rs_DSCN0385.jpg (139.58 KiB) Viewed 2331 times
- rs_DSCN0388.jpg (182.63 KiB) Viewed 2332 times
Since its a 16 point box end you don't have to turn the wrench far before you can tighten/loosen the lock nut:
- rs_DSCN0390.jpg (145 KiB) Viewed 2332 times
I can actually fit the small wrench on the adjuster while locking it down.... makes major brake adjustments take about 5 minutes per tire. Rears are even easier.
