PANEL CV-3659928
Posted:
Tue Nov 12, 2013 1:36 pmby pfarber
So I need to make some panels... specifically PANEL CV-3659928 All except NN NQ NX YN Mine are pretty beat and rusted.
- aa.JPG (34.62 KiB) Viewed 8163 times
Item AA in the figure.
TWO 4x8 sheets of 20gauge CRS is a whopping $75!!!!! $35 for each. It should only cost about $40 -50 to have the panels cut and punched. Man steel is CHEAP!
Re: PANEL CV-3659928
Posted:
Mon Nov 18, 2013 7:22 pmby pfarber
Got the steel from NIVERT Steel Co. There actually is a closer steel supply, KANE Steel, but they are assholes. Even when I asked around everyone said the same thing... they are assholes and overpriced. Evidently they only supply large shops in the area and anything less than a truckload is a waste of their time.
I have the two sheets laying on my racking... since I am nowhere near ready to get at the cab this is a back burner project.
Re: PANEL CV-3659928
Posted:
Mon Nov 18, 2013 7:37 pmby pfarber
It seems that the all metal panel was a military only thing. The Master Parts book says:
- side2.JPG (58.6 KiB) Viewed 8157 times
- side1.JPG (27.65 KiB) Viewed 8157 times
Its a pad of some sort.. either way I need some made out of steel.